WHAT IS IT COSTING YOU
To Pump Your 55 Gallon Drums?
Are you tired of constantly replacing your plastic pumps?
Are your plastic siphon pumps taking to much time to empty a 55 gal. drum?
Are you tired of cranking and plunging those labor intensive hand pumps?
Are the replacement parts for your expensive motor driven pumps too much for your
maintenance budget?
If you are experiencing any of the above problems, maybe it's time to consider the
TSI DRUM PUMP!
See it at Tailored
Systems Inc.
Simple Operation:
Thread the pump into the 2" bung of the 55 Gal. Drum.
Connect a standard compressed air line.
Check pump regulated pressure to ensure it is operating at 4 to 6 Lbs. Psi.
PUSH THE HANDLE AND WATCH IT FLOW!
Features:
- Simple to use - just hold the handle and "Watch It Flow"!
- No Cranks, plungers, or levers to continually compress.
- No Motors (Electric or Air)
- Excellent flow rates
- FM Approved Rigid Brass Safety Faucet with a Teflon Seal
and "safety lock out " (standard)
- Uses a LOW operating pressure
- Air Safety Relief Valve to prevent over-pressure
- One air source can operate Many Units
- Solid 3/4" Black Pipe construction (NOT A PLASTIC "TOY")
- Long Lasting -
no moving pump parts
Two (2) Year Warranty against manufacturer defects
Average Tested Flow Rates:* |
Weight & Dimensions: |
Water: 6 - 8 gal. per min.
|
Weight: Approx. 8 Lbs.
|
Medium weight Cutting Oil: 2-3 gal. per min.
|
Length: 44-1/2"
|
Medium Varnish: 2-3 gal. per min.
|
Width: 11"
|
|
|
|
|
*Flow rates will vary depending on air pressure and viscosity of liquid.
*For use with chemicals compatible with
Black Iron, Brass, & Teflon